Specifications

• Weight: 15,000 lbs.
• Overall dimensions: 19’-2”L x 6”W x 8’-6”H
• Floor space requirements: 23’L x 13’W x 8’6”H

Spindle:

• 2/2.5 HP, 1710/3420 RPM
• Pneumatic head travel with position lock (with pressure gauge and adjustment); stroke length: 2”
• Center water feed
• Internal air purge system
• Tool adapter to accept 100mm snail lock or 5/8-11 NC connections
• Shape tool adapter

Spindle Miter:

• 0 to 189 degree miter range
• Hydraulic rack and pinion drive
• Hardened alloy-steel C-arm with powder-coated finish

Rise and Fall:

• 3” rise and fall travel
• Round rail precision guide system
• Manual positioning with pointer/ruler display

Cross Travel:

• Hydraulic, 15-100 FPM variable speed
• Heavy-duty rack and pinion drive system
• Cross travel carried on two chrome hardened steel rails with slide bearings, automatically lubricated

Table and Clamping:

• 12’L x 4’W precision-machined tabletop work area with rubber matted surface
• Pneumatic, pop-up, “all way” rollers to assist in positioning, loading and unloading stone (2,500 lbs. total lifting capacity)
• Five adjustable, pneumatic hold downs with aluminum extension bars
• Built-in storage for aluminum extension bars
• Adjustable PARK bench to support long pieces

Construction:

• Table: Heavy-duty structural steel/plate construction, stress relieved and precision machined
• Bridge: Tubular bridge design, stress relieved and precision machined

Electrical and Plumbing Requirements:

• Electrical power at machine: 240 volt (+/- 10%), 3 phase, 60 Hz, 30 amps required
• Air at machine: 8 SCFM volume, 100 PSI pressure free of oil, water and grit larger than 25 micron (3/8” I.D. air line)
• Water supply at machine: 5 GPM, 50 PSI, filtered to 5 micron (1/2” I.D. water line with clean, fresh water)

Capabilities:

• A variety of convex edges (3/8” to 6” thick) and flat edges (3/8” to 4” thick) can be shaped and polished
• A variety of concave edges can be shaped
• Ogee edges can be shaped and polished
• Shaping and polishing length: 1’ to 12’ long
• Profile shaping and polishing thickness from 3/8” to 6” (spindle adjustment required on stone over 2-1/2” thick, must bevel corners on stone over 3” thick)
• Radius capacity: 0” to 3” radius
• “All way” rubber pop-up roller system allows work pieces to be loaded and positioned easily without scratching or breaking
• The top line can be controlled on all types of stone to achieve the profile blend that suits your needs
• Bullnose edges, including laminates, are back gauged and polished, even past the bottom transition line
• Uniform edges on each individual job
• An 80% reduction in labor cost on lineal footage can be achieved
• Unmatched setup time
• Eliminates double-cutting of laminations
• Compared to hand tools, abrasives cost per linear foot may be reduced by as much as 60%