Improper garnet hose routing can cause flow issues, see the procedure detailed below for proper garnet hose routing. When finished the garnet hose should follow a straight direct path as shown, any excess hose along the path can allow garnet to build up and cause a blockage.
Scan to Read on Device:
Choose the correct routing for the Garnet delivery hose.
1. From the abrasive regulator route
the hose through the frame
2. Route the hose through the
microwave flow sensor.
3. Route the hose through the frame.
4. Route the hose through the swivel
assembly
Routing the tubing correctly
Route the hose as shown here.
Route the hose through the frame.
Route the hose through the hose
clamp. IMPORTANT: the clamp
should NOT pinch the hose, it
should be loose enough that
the hose can slide inside the
clamp without much effort.
(Clamp part number: 9070116)
Terminating the Garnet Hose at the Cutting Head
Safely lower the nozzle. Route the hose so it has a smooth bend when attached to the nozzle assembly.
