Zoned Down Air Draft
Cutting Table
Built like a tank for both plasma and oxy-fuel cutting, the zoned down draft air table option for Park Industries KANO™ HD machines is a fab shop's best friend. Offering optimal dry cutting and maximum fume extraction, keep your facility free of dangerous fumes with this 'safety-first' cutting table design.
-
Fume Free
Cutting -
Removable Slat
Frames -
Easy Table
Cleaning

Clean, Fume Free Cutting
Park Industries® zoned down draft cutting tables are designed for heavy-duty production cutting. They offer high definition plasma cutting to 2” thick and oxy-fuel cutting to 4”. Steel damper doors for each 26” long zone open and close via mechanical levers as the gantry moves along the rails of the machine base. The exhaust flow is focused only where the torch is cutting to maximize the effectiveness of the exhaust system. Exhaust ducting is connected to a flange at the center rear of the table.
Tables include removable slat frames to allow the frame and slats to be quickly replaced as assemblies. Removable slag trays are located below the slat frames to allow the slag in the table to be quickly dumped when table cleaning is required.
Data Sheets
Table Features:
- Fabricated from A36 1/4” steel
- Single center exhaust tube with damper doors and zone partitions
- 26″ zones maximize table performance and minimize required CFM
- Mechanically activated zone doors
- Single exhaust flange at rear of table
- Removable slat frames with individual slats
- Removable slag trays
TABLE SIZE OFFERINGS
Cutting Widths:
- 5ft
- 6 ft
- 8 ft
- 10 ft
Cutting Lengths:
- 10 ft
- 12 ft
- 24 ft
ADVANTAGES & DISADVANTAGES OF DOWN DRAFT AIR TABLE
ADVANTAGES | DISADVANTAGES |
Dry cutting will produce the best cut quality and fastest speeds when cutting steel | Higher cost if heated air is exhausted from the shop to the outdoors |
Delivers maximum fume extraction if configured with a properly sized exhaust system | |
Plate and machine do not get wet and rust |