This is a quick reference guide that will help you find service guides for the Voyager.
Scan to view on mobile device
Machine Manual
The operation and maintenance manual for the VOYAGER XP from Park Industries®.
Voyager XP ManualMACHINE SOFTWARE
In this video, we will show you how to identify areas that could cause a 8258 target position or software limit alarm.
8258 SOFTWARE LIMIT OR SW LIMIT ALARM
This guide will help you restore the values on your machine if they got erased out. This guide is for Voyager that are running Hypervision/Windows 10. 1013: Axis/Axes not referenced alarm.
HOW TO RESTORE LOST MACHINE VALUES VIDEOWATER FLOW ALARM
Alarm: 1006, 1005, 700232, 700233, Recycled, Fresh, Spindle Ring Water Feed Low, Spindle Ceneter water Feed Low, Fresh Water Low, Recycled Water Low Flow, Insufficient Water Flow
HOW TO CLEAN THE WATER FLOW SENSOR VIDEOTABLE PLANING
In this video, you will learn the procedure for planing the concrete table of the Voyager saw. Watch the step by step how to guide.
How to Plane the VOYAGER XP’s Saw Table VideoZ AXIS
Walk through with a Park Industries Customer Service Rep how to perform an advanced blade touch off for accurate miter and straight cuts.
This video is done on a Saberjet but is the same concept on the Voyager.
Z OFFSET OR Advanced Blade Touch Off video
This video shows you how to calibrate the material height sensor.
This video is done on a Javelin but is the same concept on the Voyager. The calibrate button is in the setup screen
How to Calibrate the Height Sensor VideoBLADE OFFSET CALIBRATION
This video will show how to do the blade offset cut. This is one of the first things to do when you change a blade, or experience issues with blade to router alignment. This tells the machine what the offset is when it rotates C from 0 to 180. This number changes with each blade and over time. Anytime you are having issues with cut sizing this is the first step to go to.
This video is done on a Saberjet but is the same concept on the Voyager.
MITER CUT ISSUES
This guide is a list of steps you will want to go through to ensure your miter cuts are the correct size.
Correcting Miter Cuts GuideDIALING
Video showing how to dial the blade A and C on a Voyager.
Dialing Blade A and C Axis VideoY AXIS
In this video we will show you how to check and set the Y axis backlash on Voyager XP.
This video is done on a Saberjet but is the same concept on the Voyager.
How to Set and Check Y Axis Backlash Video
In this video we will show you the process of replacing the Y axis drive gears on a Voyager XP.
This video is done on a Saberjet but is the same concept on the Voyager.
How to Replace the Y Axis Drive Gear Video
In this video we will show you how to square the bridge for Voyager XP. Bridge can become skewed if crashed hard enough or in the event of changing out a pinion gear, bearing, rails or gear rack.
This video is done on a Saberjet but is the same concept on the Voyager.
Squaring the Bridge VideoGREASE MALFUNCTION
This video will go through how to diagnose grease flow issues on the Voyager.
How to Troubleshoot Grease Flow Issues, Grease Flow Malfunction Alarm