Micro PC Restore – restoring disk image

Guide Number: SG0741 | Printer Friendly Version | View Safety Disclaimer

This document illustrates the steps required to restore a disk image or system backup on a Siemens Micro
PC. This procedure can be used when setting up a new PC or to overwrite corrupted files on an existing PC.

Restoring a disk image will erase all of the data on the micropc and replace it with data that was current at the time the image was created.

If possible before running the ghost program, backup the CNC Router Data Folder or CNC Sawjet Data Folder on the C drive.

Shutdown the machine control software and remove power from the machine using the steps below.

Once the machine has been shutdown, locate and install the USB flash drive which holds the backup disk image into an open USB port on the MicroPC.

Turn power back on to the machine and then follow the steps to run the utility.

Last updated: June 3, 2022

Need Some Help?

Contact Park Industries® Customer Service
800-785-3391 | customerservice@parkindustries.com

ATTENTION

Prior to beginning installation, operation, or maintenance, you are advised to carefully read ALL instruction manuals and ALL safety materials and procedures provided with your equipment.

You are solely liable for the proper operation and maintenance of the equipment.

Park Industries® is not responsible for and expressly disclaims liability for any injuries (including death) or damage to the equipment or any other property as a result of improper operation or maintenance of the equipment, as well as failure to comply with the procedures set forth in the equipment’s instructional manual or any other safety materials and procedures. If you encounter any problems or difficulties, you are strongly encouraged to seek professional assistance.

Safety is our number one concern. Should you have any questions don’t hesitate to call our service team at 800-785-3391.

Acknowledge