Adding the right machinery provides real results. Understand the impact at these shops.
Guide Number: SG1846 | Printer Friendly Version | View Safety Disclaimer
Fairly easy task, requires minimal mechanical/electrical experience.
Need to stop a profile/polish from running to far along an edge of a piece? Programming a Finished Return consists of calculating the distance to stop the cut and drawing in the Lead in and outs to pull the cutter away.
Chapters:
0:00 Introduction
0:15 Measuring the Tools
1:57 Calculating the Break Distance
3:03 Breaking the Cut Geometry
4:19 Creating a Lead In and Out
6:11 Lead Creation Method 2
7:52 Apply Cuts and Simulate
stopping a tool before a nock wall seam
Last updated: May 28, 2025
Contact Park Industries® Customer Service
800-785-3391 | customerservice@parkindustries.com
Prior to beginning installation, operation, or maintenance, you are advised to carefully read ALL instruction manuals and ALL safety materials and procedures provided with your equipment.
You are solely liable for the proper operation and maintenance of the equipment.
Park Industries® is not responsible for and expressly disclaims liability for any injuries (including death) or damage to the equipment or any other property as a result of improper operation or maintenance of the equipment, as well as failure to comply with the procedures set forth in the equipment’s instructional manual or any other safety materials and procedures. If you encounter any problems or difficulties, you are strongly encouraged to seek professional assistance.
Safety is our number one concern. Should you have any questions don’t hesitate to call our service team at 800-785-3391.
