Guide Number: SG0761 | Printer Friendly Version | View Safety Disclaimer
This guide will show how to replace the water union for the TITAN 2K & 3K series.
Remove water and weep lines from the water union
Remove fittings in water union. Incoming waterline fitting has an 3/8″ allen wrench socket inside the fitting for removal.
Remove anti-rotation bracket
Remove draw bar air cylinder by removing four 3/4″ bolts.
lift cylinder straight up to remove, use caution so not to disturb draw bar sensor
Remove water union using provided wrench to hold draw bar stationary.
water union has reverse threads!
Reassemble in reverse sequence.
Last updated: May 18, 2021
ATTENTION
Prior to beginning installation, operation, or maintenance, you are advised to carefully read ALL instruction manuals and ALL safety materials and procedures provided with your equipment.
You are solely liable for the proper operation and maintenance of the equipment.
Park Industries® is not responsible for and expressly disclaims liability for any injuries (including death) or damage to the equipment or any other property as a result of improper operation or maintenance of the equipment, as well as failure to comply with the procedures set forth in the equipment’s instructional manual or any other safety materials and procedures. If you encounter any problems or difficulties, you are strongly encouraged to seek professional assistance.
Safety is our number one concern. Should you have any questions don’t hesitate to call our service team at 800-785-3391.