Adding the right machinery provides real results. Understand the impact at these shops.
Find help for our most popular machines here.
Or view all of our support materials here >
Get started by searching keywords and filtering by topic to find what you are looking for more quickly.
Not finding what you are looking for? Call our 24/7 customer service at 800-785-3391.
The following procedure illustrates assembly of Optimus Axis #6 Coil. Assemble coil by threading it around the neck of axis four just above the robot wrist. **Note: use masking tape or alike to protect painted surfaces while sliding the coil tubing against the robot. Leave protective caps on the coils threaded ends to avoid damaging […]
It has come to our attention that the threads on inside of the arbor motor could become damagedbeyond the point of use if the adapter is not tightened properly during normal use. If the router tool is not secured into the arbor motor properly at time of installation and throughout the use of the router […]
Common operation occurrences for a new Saberjet During the first few months of operation, it is common for some connection points to become loose, and leak water. As your machine cycles from no pressure to high pressure, this causes the metal components to expand and retract, which can result in connections coming loose. To correct […]
Troubleshooting garnet flow restricted alarms. Step by step process to locate and correct garnet blockages Connect the blue line to the bottom of the mini-hopper once the tubing cleared If you don’t have the correct flow, either turn the round dial up if you need more garnet or down if you have too much. If […]
A step by step procedure for addressing the Mini Hopper overflowing conditions
This document outlines key elements that should be followed to maximize spindle life. Failure to follow all of these items listed below will reduce the life cycle of the spindle. Use only fresh, tap water through the spindle (per machine specifications – contact Park Industries customer service for details. Poor water quality can cause buildup […]
This procedure illustrates the steps to remove, clean and replace the Quantum Drive spindle gripper set. A companion video can be viewed also. If you have a quickset style gripper -> follow this video The Tools needed to remove/replace the gripper set are: Gripper Tool – (Figure 1) Tool tabs align with slots in gripper […]
It is very important that before running your new spindle with the used tool holders you have completed what is highlighted in the spindle care document. See Spindle Care: https://www.parkindustries.com/service/belt-drive-spindle-care/ This procedure illustrates the steps to remove, clean and replace the Quantum Drive spindle. A companion video can be viewed: Spindle Removal Video: Spindle Install […]
To help ensure you are getting the longest service life from your TITAN 1000 Series’, FabCenter, & DESTINY’s rotary union make sure the following steps are being taken when installing a new rotary union. Always make sure you are using the proper tools. ONLY use the correct size wrench to remove and install the rotary […]
The overhead laser is a positioning tool used for locating vacuum pods and parts. As the day goes on and shop temperatures fluctuate, the overhead laser accuracy is affected. As much as a half inch of error may be noticed if the laser is not calibrated before each table load of parts. There are two […]
This guide is intended to remedy vacuum issues at -19 in/Hg or less. Before starting troubleshooting, make sure these conditions are made: • Stone is in place on vacuum pods and in position on table • Vacuum Pump is ON • Verify that all appropriate manifold valves are on Verify manifold valves are in the […]
An Over-cycle alarm can be caused by several things. This list is the best way to check off the easy items and quickly find the issue. Check incoming water pressure. Be sure the main supply of fresh water for the cutting head hasn’t been shut off, or the filters aren’t dirty. In the machine setup […]
