Stay Safe and Strong. Park Industries® Response to COVID-19.

Learn More

All guides listed below. Search keywords and filter by topic to find what you’re looking for more quickly.


  • Search/Filter

  • Content Type

  • Products

Reset Filters

(240) Results

Intensifier Repair Videos

  • Service

Skill Level: 2 Estimated time to complete: 45-90 min High pressure seals and poppet This video shows how to replace the seals inside the high pressure cylinder on the intensifier. Also shows low pressure poppet and check valve servicing. Hydraulic seal replacement This video shows you how to remove and replace the hydraulic seals and […]

Denison card tuning

This procedure will assist in adjusting or setting up a new or current Denison Hydraulic Controller. Skill Level estimated time to complete: 1 – 1 1/2 hours If your cross travel is not stopping in a consistent location, check the following. Make sure the limit flag maintains a constant distance from t he cross travel […]

Pro Edge II, III, IV Spindle Overload Tripping

This document illustrates the steps required to troubleshoot the possible causes of the overload(s) tripping for the spindle motor in the main electrical panel causing an alarm on the screen. WHILE PERFORMING THIS PROCEDURE ENSURE ALL LOCK OUT / TAG OUT POLICIES IMPLEMENTED BY YOUR COMPANY ARE FOLLOWED CLOSELY. Skill Level Estimated time to complete: […]

Travel block replacement

This procedure will instruct you on the removal and re-assembly of the travel blocks supporting the hold down assembly. WHILE PERFORMING THIS PROCEDURE ENSURE ALL LOCK OUT / TAG OUT POLICIES IMPLEMENTED BY YOUR COMPANY ARE FOLLOWED CLOSELY. Skill Level Estimated time to complete: 6-8 hours Removal Power off machine and Lock Out Tag Out. […]

Adjusting Miter Home Position Coordinate

This document illustrates the steps required to adjust the Miter Home Position Coordinate on a Velocity machine. The miter on the Velocity homes off of a proximity sensor mounted by the compensation arm on the exit end of the machine. If this proximity sensor is adjusted, moved, or replaced the following steps need to be […]

Yoke bearing replacement

The procedure covers the removal, replacement of yoke bearings and seals and assembly. Skill Level Estimated to to complete: 1 Hour Remove and label air all air lines. Remove water union or new style water union bracket. Remove large nut from bottom of both air cylinders with a 1-1/16″ wrench. (You might have to hold […]