This video will show how to set your spindle Z height.
This video will show you how to set, and check your tool pocket locations. Refer to “SETTING TOOL POCKET LOCATIONS-VIDEO”. Pendant Assist feature will work similar to what is shown in the video. After referring to this video because the pendant doesn’t match the one shown in video for Destiny and early model Titans refer […]
This video will show how to clean the water flow sensors if you are getting fresh or recycled water flow alarms.
This video shows you how to set the spindle to laser offset.
This video demonstrates how to align and square up the crosshair laser on the Titan.
This video demonstrates how to purge and verify grease is going to each axis for your Titan CNC Router.
This list is some suggested parts to have on hand to help minimize downtime for the TITAN 2000 series. Also see the Titan Consumable and Tool Parts list to reduce downtime as well.
This list consists of common consumable parts & tools that are suggested to have on hand to help minimize downtime on the TITAN 2000 Series. Click Titan Spare Parts list as well for further reduction of downtime parts.
This document outlines key elements that should be followed to maximize spindle life. Failure to follow all of these items listed below will reduce the life cycle of the spindle. Use only fresh, tap water through the spindle (per machine specifications – contact Park Industries customer service for details. Poor water quality can cause buildup […]
This procedure illustrates the steps to remove, clean and replace the Quantum Drive spindle gripper set. A companion video can be viewed also. If you have a quickset style gripper -> follow this video The Tools needed to remove/replace the gripper set are: Gripper Tool – (Figure 1) Tool tabs align with slots in gripper […]
It is very important that before running your new spindle with the used tool holders you have completed what is highlighted in the spindle care document. See Spindle Care: https://www.parkindustries.com/service/belt-drive-spindle-care/ This procedure illustrates the steps to remove, clean and replace the Quantum Drive spindle. A companion video can be viewed: Spindle Removal Video: Spindle Install […]
To help ensure you are getting the longest service life from your TITAN 1000 Series’, FabCenter, & DESTINY’s rotary union make sure the following steps are being taken when installing a new rotary union. Always make sure you are using the proper tools. ONLY use the correct size wrench to remove and install the rotary […]