A step by step video guide on how to edit a style in Alphacam.
A step by step video guide on how to setup tool oscillation in Alphacam.
These videos (Part 1, 2 and 3) illustrate the basic setup and operation of the Integrated Tool Management (ITM) system found on most Park Industries Titan CNC Routers. There are three videos which cover R values, Titan tool library, and ITM Operation. Search Keywords: Tool Library Offsets Fine Adjust Adjusting Diameter Length Number RPM Speed […]
These videos (Part 1, 2, 3 & 4) illustrate the steps required to properly prepare, setup and test tools on the Titan prior to deploying them for normal operation. Part 1 – Digitize a Part Part 2 – Creating a Program Part 3 – Testing and Adjusting Part 4 – Testing and Adjusting Polishers
To show an example of how to program a shower pan using the Core bit and Finger bit for the drain hole and drain flange, and the gauge wheel for the shower pan slope. A few things to consider before starting. Draw the shape for the application. (Shower pan, Profile Geometry, Drain Hole, Drain Flange) […]
A step by step video guide how to properly create a style in Alphacam which includes converting a cut path into a style.
Step by Step Video Guide on how to complete a Quantum Drive Belt Replacement on the TITAN 2000 series. Besure to complete spindle orientation after replacing the spindle drive belt. https://www.parkindustries.com/service/spindle-orientation-video/
Step By Step Video Guide on how to wire the Quantum Spindle Sensor on the TITAN 2000 series. This is the 1st model of T-coupler Park Industries used. This is the 2nd model of T-coupler Park Industries used. This is the 3rd model of T-coupler Park Industries used.
Step by step video guide on how to replace the Draw Bar on the QUANTUM Drive Spindle on the TITAN 2000 series.
This use of this guide requires tools to be made in Alphacam under the Machine Tab. If you are unfamiliar with how to create tools in the Machine Tab- such as FLAT END or USER DEFINED TOOLS- please watch our video link below to create additional tooling first. 0:00 Introduction 0:13 Tooling 1:55 Drawing Drain […]
This use of this guide requires tools to be made in Alphacam under the Machine Tab. If you are unfamiliar with how to create tools in the Machine Tab- such as FLAT END or USER DEFINED TOOLS- please watch our video link below to create additional tooling first. Tags: drainboards boards The following procedure lists […]