Adding the right machinery provides real results. Understand the impact at these shops.
Find help for our most popular machines here.
Or view all of our support materials here >
Get started by searching keywords and filtering by topic to find what you are looking for more quickly.
Not finding what you are looking for? Call our 24/7 customer service at 800-785-3391.
Video shows how to service high pressure poppet, check valve and low pressure poppet.
This document illustrates the steps required to adjust the Miter Home Position Coordinate on a Velocity machine. The miter on the Velocity homes off of a proximity sensor mounted by the compensation arm on the exit end of the machine. If this proximity sensor is adjusted, moved, or replaced the following steps need to be […]
The procedure covers the removal, replacement of yoke bearings and seals and assembly. Skill Level Estimated to to complete: 1 Hour Remove and label air all air lines. Remove water union or new style water union bracket. Remove large nut from bottom of both air cylinders with a 1-1/16″ wrench. (You might have to hold […]
An error has been found in the TITAN ITM Calibration Tool Setup procedure. Please ensure that step A (shown below) reads 0.1 and not 1.0 in your TITAN Operation and Maintenance manual. This screen is located in the following Operation and Maintenance manuals: TITAN 1700 – page 4-111 or page 4-113 TITAN 1600/1800 manual – […]
This procedure will work on the Pro Edge II thru IV and Velocity polishing spindles. skill level 3 estimated time to complete: 4-5 hours Rebuild kit contains all parts necessary. Park Part # 65672 Tools Required: Part # 40142 20mm spanner wrench Part # 42146 30mm spanner wrench Part # 47425 Collar wrench Standard Tools […]
This document illustrates the steps necessary to properly install a new conveyor belt on a Park Industries Fastback machine. skill level Estimated Time to complete: 3 – 4 hours Before installing the replacement belt, remove it from the box for a few hours prior to installation and lay it in the sun if possible. This […]
This document illustrates the steps necessary to properly replace a spindle motor on a Park Industries Fastback machine. Skill level 2 estimated time to complete: 30 minutes Power down the machine at the wall. Follow your companies internal lockout/tagout procedures. Open the junction box on the motor, make sure to label the wires then disconnect […]
This will help with remote connectivity to a Windows NT control
If your cross travel surges as you are moving and then completely stops there is a good chance there is not oil going to the bearings. Skill level Estimated time to complete: 30 minutes Look on top of the machine at the oil level in the jug and make sure it is at an acceptable […]
This procedure will ensure that the distance the belt travels is accurate and will cause the machine staggers to act in a proper manner. Skill Level Estimated time to complete: 15 minutes
This document illustrates the steps required to replace the cross travel linear slide bearings on a Park Industries Pro Edge III or IV machines. Cover the table top with plastic to keep the rubber work surface free from oil in case the drip tray needs to be removed. Oil will penetrate the rubber top causing […]
introduction: For this upgrade, two 3/4″ water lines are required: one for the halo recycled water and one for the spindle fresh water. Water flow results depend on water supply. The optimal set up would be a 4″ main with two 1″ drops; one for recycled and one for fresh water. see step 18 for […]
