Adding the right machinery provides real results. Understand the impact at these shops.
Find help for our most popular machines here.
Or view all of our support materials here >
Get started by searching keywords and filtering by topic to find what you are looking for more quickly.
Not finding what you are looking for? Call our 24/7 customer service at 800-785-3391.
This video will show you how to set and check your machines tool pocket z location.
A step by step procedure to calibrate the SL Laser to a Destiny or Titan Router table Power up the Destiny XE / Titan and start the Front end software. When everything is up and running press the Set-up button on the main page. Inside the Set-up Page press the ‘Advanced Setup’ button. Enter the […]
This guide will demonstrate how to replace your ball screw on Titan and Fusion machines. The ball screw is what the Z axis travels on to move up and down. FOR YOUR SAFETY: You Must do the following to keep the rise and fall from sliding off of the rails during the next steps Do […]
This document illustrates the steps required to restore a disk image or system backup on a Siemens Micro PC. This procedure can be used when setting up a new PC or to overwrite corrupted files on an existing PC. Restoring a disk image will erase all of the data on the micropc and replace it […]
This video will show how to set your spindle Z height.
This video will show you how to set, and check your tool pocket locations. Refer to “SETTING TOOL POCKET LOCATIONS-VIDEO”. Pendant Assist feature will work similar to what is shown in the video. After referring to this video because the pendant doesn’t match the one shown in video for Destiny and early model Titans refer […]
Preliminary steps to gain access to the ‘X’ axis bearing for removal and replacement Remove the x axis servo motor from the machine or lower them out of the gear rack, remove the 4 bolts on each motor. Loosen these bolts (two additional on other side) and lower the gearbox out of the rack, if […]
A step by step guide for removal, inspection, cleaning and reinstalling the Weiss Gripper Finger Set Tools required 1) Depth micrometer 3-4inch, Park Industries# 3094001, Grainger #4KY22 2) 5mm T-handle Allen wrench 8-10inch, Park Industries# 8200374-7 3) Gripper finger adjustment tool, Park Industries# 8200374-8 4) Gripper removal tool, Park Industries#5213007, Threaded rod M8x1.25 10” 5) […]
A step by step guide on how to operate the Park Industries Fastback II
This video will show how to clean the water flow sensors if you are getting fresh or recycled water flow alarms.
This video shows you how to set the spindle to laser offset.
This video demonstrates how to align and square up the crosshair laser on the Titan.
